This is our new GTO shaft made with 3-3/8 Carbon fiber (was 3-3/4 but changed to 3-3/8 for better clearance) , we have done extensive work on a new bonding system and have had great success with testing in both the lab and the real world (click here for test results). The shaft is rated for 1000+ Hp and will come with a Strange billet Trans yoke of your choosing (depending on transmission used) The shaft will also be mounted to the rear with a our 4340 billet pinion flange and 1350 Spicer flange. The reason we have done it this way instead of the pinion yoke is we have found that flange mount will have more repeatability for balance than a traditional pinion yoke (click here for a full article on flange VS yokes) These shafs are made to order and normally will take 7-14 days to produce. this like all shafts are balanced on our new exclusive 9500Rpm balancer (click here for info)
The only necessary modification is the tip of the rear seatbelt bolt that protrudes into the driveshaft tunnel must be ground down to provide adequate clearance for the driveshaft.